![]() With ventoy, you don’t need to format the disk over and over, you just need to copy the ISO/WIM/IMG/VHD(x)/EFI files to the USB drive and boot them directly. Ventoy is an open source tool to create bootable USB drive for ISO/WIM/IMG/VHD(x)/EFI files. When GNOME Disk Utility opens, specify the flash drive from the Destination drop-down menu and click Start Restoring. iso file, and select Open With Disk Image Writer. Linux distributions running GNOME can easily make a live CD through nautilus and gnome-disk-utility. Popsicle is a Linux utility for flashing multiple USB devices in parallel, written in Rust.Īnd known to work nicely for EndeavourOS ISO. Or even cp: su cp /path/to/endeavouros-x86_64.iso /dev/ sdXĪnd exactly tee can do it too: su tee /dev/ sdxīut keep in mind and check your command 3 times before executing, as putting something wrong will possibly destroy personal data! GUI’SĪll GUI writers can be installed using yay -S packagename as mentioned below: Using cat (with progress) su cat /path/to/endeavouros-x86_64.iso | pv > /dev/ sdX To write the Live Install image to your USB run the following command: sudo dd bs=4M if=/path/to/endeavouros-x86_64.iso of=/dev/sdX conv=fsync oflag=direct status=progressīut indeed Linux has possibilities without ending: Note: the USB drive may not be mounted when writing an ISO to it! So make sure you umount it first: sudo umount /dev/sdX To view a list of all drives currently attached to your system run this command: sudo fdisk -lĪnother command to show information about the drives: lsblk -f The most common path of a USB drive is /dev/sdb BUT yours might be different depending on your system. NOTE: The USB drive is specified as /dev/sdx and not /dev/sdxX. Just change the paths to the correct paths for your system. The dd command will almost always result in a working Live USB. We are going to focus on only the two recommended methods which are dd from the command line and SUSE Image Writer from the GUI. There are many methods of creating Live USB images using Linux. Some of the more widely known utilities that fall into this category are: For best results, it is recommended that you NOT use these types of utilities to create your Live USB. There are workarounds to fix the failure but that is beyond the scope of this article. Now you can install Ubuntu 20.04 without issues.Some USB Writing utilities alter the labels of the partitions included in the ISO image. Reboot computer and windows should start up normally again.Right-click the Windows Start Menu and click on Command Prompt (Admin).Reboot your computer to make sure BitLocker is disabled.Click on Turn off BitLocker (wait on the decryption to finish – it is indicated in the system tray).Click on start and type manage BitLocker and launch it as an administrator.Boot into your Windows operating system. ![]() We will need to turn off Bitlocker for Ubuntu to be able to access the files in the Windows C: Drive, and then we will also need to change the storage controller protocol from RST (Redundant Array of Independent Disks - RAID) to Advanced Host Controller Interface ( AHCI): Intel(R) RST was enabled, that is, Redundant Array of Independent Disks (RAID)īitLocker was turned for my Windows C: Drive which I wanted to install Ubuntu alongside The issue can be caused by more than one factor. I also tried using UNetbootin to burn the Ubuntu 20.04 ISO file into the USB Flash drive, but it gave me the same error. Initramfs unpacking failed: Decoding failed I downloaded the ISO image and then burnt it into a USB Flash drive using Rufus, when I tried to install, I got the error I experienced this issue when setting up Ubuntu 20.04 on my Dell PC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |